The 10 Most Common Plumbing Problems
You don’t realize how you depend on plumping until you start having problems. It could be your drains are clogged, your shower is leaking or your HVAC has stopped working. While some of those issues are simple enough, others are better left to a plumber.
Interestingly, when a plumbing problem needs fixing it needs fixing immediately. Although some problems are more serious all of them require your attention especially if you want a peace of mind. Here are some of the most common plumbing problems, their causes and how they can be fixed.
1. Slow draining sink
This problem is normally attributed to a blockage that’s preventing water flow. Your kitchen sink may contain things such as food remnants and congealed fats that might. In a bathroom, this blockage may be caused by soap or knotted hair.
Although there are different methods for clearing clogged sink the most common ones involves pouring down vinegar or baking soda, using a plunger or using a plumber snake. Unfortunately, if this problem is not handled immediately, it’s likely to become worse and completely block the drain.
2. Leaky pipes
Leaking pipes are also some of the most common problems in houses and apartments. Leaking pipes are not only annoying but also waste money. In fact, by fixing the leaks you can save up to 10 percent of your water bill. Since the water physically leaks, it’s very easy to spot a leaking faucet. If you don’t catch the problem they can cause major damage.
3. Leaking faucet
A dripping faucet usually occurs when the seal on the tap gets damaged. This damage occurs when the seal is no longer tight. The best way to solve this problem is to replace the washer that’s responsible for the seal. However, if you don’t have enough skills it’s advisable to call a plumber.
4. Running toilet
A running toilet can be very expensive. You may end up losing up to 200 gallons of water each day. The most common cause of this is a faulty flapper valve that normally controls the water. Thankfully, with a toilet repair kit, it’s a fairly straightforward fix that can be done by anyone.
Running toilets may also be caused by small sediments affecting the filling and flushing. If your water bill suddenly rises, it’s time to check for any silent leaks.
5. Low water pressure
If you are staying in an old house then this is a very common problem. However, this does not mean that it cannot occur in new houses. Low water pressure can either be sudden or start slowly and get worse after some time depending on the cause.
Whatever the cause, low water pressure may make it hard to shower or even to rinse things. It’s, therefore, very important to resolve the issue as soon as possible.
Some of the causes include water main break, leaking pipes or a buildup of sediments and minerals either in the faucet aerators or the pipes. The first step is to know the cause. However, if you cannot pinpoint the cause, then you need to call in a professional plumber.
6. Faulty water heater
You might not discover this problem until you get into a shower and the water suddenly gets cold. There are a number of issues that can make a water heater to fail. There might be a buildup of sediments, the pilot light may go off or the thermostat may be having a problem.
Unless the problem is a simple fix such as adjusting the thermostat or relighting the pilot heater, you need to call in professional inspect, maintain, and repair the heater problem.
7. Clogged toilet
When the toilet bowl fills up without draining away then there is clog. This kind of blockage is normally caused by a mixture of paper and human waste. Thankfully these problems can easily be fixed with a plunger. However, if that doesn’t work a drain auger or a sewer snake should be used to loosen it up.
8. Jammed garbage disposal
While garbage disposals are very important, sometimes they do jam. Disposing of certain food substances, running them without enough water or allowing silverware to get in may lead to problems. If you want to fix the issue the first set is to press the reset button. But if this fails you need to open it up.
9. Sewer system backup
A Sewer system backup can be a major problem when it comes to plumbing issues. They are not only smelly but also nasty and very expensive to fix. If you have several toilets and drains not working there is likely to be a problem. Fixing this problem normally depends on the location. While the water company should fix it if it’s on your property you need to fix it alone.
10. Sewer gas smell
If you have a trap problem then there is likely to be a sewer gas smell. Always filled with water, the trap prevents sewer gas smell from getting into the house. However, if the water evaporates then sewer smell might leak into the house.
Top 6 tips to help you handle your own plumbing issues
• Before fixing the problem ensure that you fully understand it. However, if you don’t feel comfortable fixing it, call a professional plumber
• To prevent any major damage shut off the main supply.
• Gather all the tools and supplies needed for the whole project. There is nothing as bad as starting a project only to realize that you need something. Also, ensure that everything you buy will fit and work in your system.
• Since plumbing work can get messy put on old clothes.
• Make sure you have a plumber on standby in case the project does not turn out well.
• You need to know where to turn off the main water supply.
• Do not block sewer cleanouts or water supply valves.
• If you are not sure about the problem contact a plumber as soon as you can
• Make sure you choose a reputable and certified plumber.
Plumbing issues can be both annoying and dangerous. From dripping pipes to leaking taps, there are many different kinds of plumbing problems. Although some problems are easy DIY, others require the attention of a professional. The first step is, therefore, to diagnose the problem and see if you can handle it. If not, do not hesitate to call a reputable and certified plumber to help bring your life back to normal.